Laser Service

Laser Source Repairs

Diagnosis and repair of resonator and fiber source faults to bring output power back to spec

Schedule Service

What Is Included

Power Output Diagnosis

The resonator or fiber source is tested to identify the cause of reduced or unstable output power

Component Repair or Replacement

Faulty diodes, modules, or internal optics are repaired or replaced to restore proper source function

Output Verification

Power output is measured and verified against factory specification before we leave your shop

Ready To Schedule Your Laser Source Repair

Fill out the form below and our service team will confirm a time that works for your shop

Laser Source Repairs FAQs

Answers to the most common questions about this service

What are signs my laser source is failing?
Reduced cutting speed, inconsistent power readings, failure to pierce thicker material, or an outright loss of beam output are common signs the source needs attention.
Do you repair both fiber and CO2 laser sources?
Yes, our technicians diagnose and repair both fiber laser modules and CO2 resonators, using the correct testing procedure for each type.
Can a laser source be repaired or does it need replacing?
In many cases a faulty diode, module, or internal component can be repaired or replaced without swapping the entire source. Our technicians confirm this during diagnosis before recommending a repair or a full replacement.
How long does a laser source repair take?
Diagnosis time varies depending on the fault, and a straightforward repair can often be completed on site, while a part replacement may take longer if a component needs to be sourced first.
Will you verify the repair before you leave?
Yes, output power is measured and verified against factory specification before the job is considered complete.
Do you service laser sources outside the GTA?
Our laser source repair service is not limited to the GTA. Contact our service team with your location and we will confirm availability for your shop.