Laser Service

Laser Cutting Head Maintenance

Cleaning, calibration, and lens inspection to maintain cut quality and extend head life

Schedule Service

What Is Included

Lens Cleaning and Inspection

The focusing lens and protective window are cleaned and inspected for pitting, contamination, or burn marks

Nozzle and Alignment Check

Nozzle condition and beam centering are checked and corrected to keep cuts clean and consistent

Calibration and Test Cut

Height sensing and focus are calibrated, then verified with a test cut before we leave your shop

Ready To Schedule Your Laser Cutting Head Maintenance

Fill out the form below and our service team will confirm a time that works for your shop

Laser Cutting Head Maintenance FAQs

Answers to the most common questions about this service

How often should a laser cutting head be serviced?
Most shops schedule cutting head maintenance on a set interval of cutting hours or roughly every few months under regular production use, whichever comes first. Heavier material use or lower quality assist gas can call for more frequent service.
What are signs my cutting head needs maintenance?
Rough or inconsistent cut edges, excessive dross, reduced cutting speed, or visible marks on the lens are all signs the head is due for cleaning and inspection.
Can a dirty lens damage my laser?
Yes. Contamination on the lens absorbs energy instead of transmitting it, which generates heat and can lead to lens cracking or damage to the cutting head over time if left unaddressed.
How long does cutting head maintenance take?
A standard service typically takes a couple of hours on site, including cleaning, alignment checks, calibration, and a verification test cut.
Do you service both CO2 and fiber laser heads?
Yes, our technicians service cutting heads on both CO2 and fiber laser systems, using the correct cleaning and calibration procedure for each type.
Do you service laser cutting heads outside the GTA?
Our laser cutting head maintenance service is not limited to the GTA. Contact our service team with your location and we will confirm availability for your shop.